Adding a Connection Broker

Prev Next

The Connection Broker handles NAT traversal in the AppGate ZTNA system. This section describes how to configure a Connection Broker on an AppGate appliance.


Before adding a Connection Broker

Before adding a Connection Broker, review the NAT traversal in AppGate ZTNA section.


Configuring a Connection Broker

To configure a Connection Broker:

  1. In the Add/Edit Appliance page, select the Connection Broker checkbox in the Functions tab.

  2. Complete the following configuration fields:  

Site Settings

  • Appliance Site. Select the Site from the dropdown list.

System TLS Connection (using SPA)

These settings are used for peer‑to‑peer traffic:

  • TLS Port. The inbound TLS connection port to the appliance.

  • Allowed Sources. Select +Add to add one or more allowed sources by adding the Address, Netmask Length, and the Network Interface. The requesting IP address must match at least one allowed source.

  • SPA Mode. Allows the SPA mode to be changed for a specific appliance. Select one of the following:

    • No override

    • Check TCP SPA key before allowing connections

    • Check UDP (and TCP) SPA key before allowing connections

  • Enable proxy protocol. When enabled, the appliance accepts only packets that include a proxy protocol header. AppGate ZTNA supports proxy protocol versions 1 and 2.

NOTE

When traffic originates from a known source, add that source to Allowed Sources. Failure to do so introduces a security risk.

Broker Configuration

  • STUN/QUIC Port. Enter the port used by the Connection Broker. The default value is 443.

  • Site Connections. Select one of the following options:

    • Broker connections for all Sites. Creates a broker connection for all Sites.

    • Broker connections for specific Sites. Creates broker connections only for selected Sites.

      • Sites. Select +Add to add specific Sites.

After completing the Connection Broker configuration, continue to the Miscellaneous tab.