AppGate ZTNA uses IP pools to assign an internal IP address to clients, including clients in the Connector or Portal. The virtual tunnel interface uses this address for client-to-Gateway communications.
AppGate ZTNA includes default IP pools for both IPv4 and IPv6:
Check the default settings for both IP pools and increase the pool size if you have many users.
Remove the default IPv6 pool If you are not using IPv6 for your client-to-Gateway tunnels.
After you configure IP pools, you can allocate them in the following places:
Identity Provider. Primary usage. In the identity provider (IdP), you can assign tunnel IP addresses for any user authenticating through that IdP.
Site. Optional. You can map the primary IP address to an alternative IP address for a given Site.
Prerequisites
Before you set up an IP pool, gather the following information:
One or more ranges of free IP addresses for users connecting through AppGate ZTNA.
An understanding of any Sites where an IP address conflict might occur.
Adding an IP pool
To add an IP pool:
Go to IP Pools (Identity > IP Pools).
Select +Add and complete the following fields:
NOTE
You cannot delete or modify an existing range within an IP pool because it may already be in use.
Name. Enter a name for the IP pool.
Notes. Optional. Enter any notes for the IP pool.
Tags. Click +Add to add tags to the IP pool.
IP Version. Specify the IP address protocol to use.
Lease time (days). Duration for which an assigned IP address remains reserved for a specific client. You can set up to a maximum of 1095 days (3 years).
Ranges. Ranges of IP addresses assigned to clients. Add ranges using CIDR notation (192.168.100.0/24) or a start and end IP address (192.168.100.1–192.168.100.5). Ranges cannot be edited or removed once saved.
Excluded Ranges. Ranges of IP addresses not assigned to clients. Excluded ranges (in the same format) can be added, edited, or removed. When a client's entitlement token renews, the client is reassigned elsewhere in the range. Each IP pool can include multiple ranges; add more ranges later if space is running low.
Default IP Pool ranges:
<default pool v4>:
192.168.100.1-192.168.100.254<default pool v6>:
fd00::ffff:c0a8:6401-fd00::ffff:c0a8:64fe
NOTE
The default IPv4 and IPv6 ranges allow for only 254 addresses out of the box.
If SNAT is disabled on a Site, you may need to add routes to the network to reach the IP pool address blocks defined here.
Select Save to add the IP pool.