Configuring MFA providers

Prev Next

Configuring an MFA provider lets you allow or restrict user access to resources. AppGate ZTNA includes a built-in, time-based OTP provider and a built-in FIDO2 provider, and it supports external RADIUS multifactor authentication (MFA) providers. After you configure MFA providers, you can use them to create user interactions in conditions, enforce MFA for admins, or configure onboarding mode for each identity provider (IdP).


Before you configure MFA providers

Before you set up an MFA provider, make sure you have the following information:

  • For a RADIUS server, you will need:

    • Hostname/IP address

    • Port

    • Authentication protocol

    • Shared secret

    • Shared secret challenge


Configuring an MFA provider

On the MFA Providers page (Identity > MFA Providers), you can edit the default providers or set up a new MFA provider.

Using Default Providers

Default Time-based OTP Provider

See the Default time-based OTP provider section for more details about OTP implementation in AppGate ZTNA.

To edit the default time-based OTP provider, select it from the MFA Providers page and complete the following field:

  • Pin Entry Type. Select one of the following:

    • Masked. Hides the PIN as the user enters it.

    • Numeric (6 digits). Uses a numeric keypad.

    • Text. Allows alphanumeric entry.

Default FIDO2 Provider

See the Default FIDO2 provider section for more details about FIDO2 implementation in AppGate ZTNA.

Adding New MFA Providers

To add a new MFA provider:

  1. Go to MFA Providers (Identity > MFA Providers).

  2. Select +Add and complete the following fields:

Server Settings

  • Hostnames or IP Addresses. Select +Add to enter the hostnames or IP addresses for the RADIUS server. You can enter more than one host. When AppGate ZTNA needs to contact a RADIUS MFA server, it selects a host at random.

NOTE

The AppGate ZTNA system ensures that a process started with one RADIUS server finishes with the same server. However, there is still a chance it may finish with another server and a message will be lost. Make sure your RADIUS server settings mitigate this scenario.

  • Port. Enter the port number of the RADIUS server.

  • Timeout (seconds). The time in seconds that the AppGate ZTNA system waits for a response.

Authentication

  • Authentication Protocol. Select the protocol used to log in to the RADIUS server: CHAP or PAP. Use CHAP if possible. Depending on your selection, you can send either a fixed text string or the user's password back to the RADIUS server in the Access-Request User-Password field.

  • Shared Secret. Enter the shared secret for the RADIUS server.

  • Authentication mode. Select a mode from the following:

    • Appgate SDP pre-emptive MFA. The user is prompted for an OTP, and the RADIUS server validates it.

    • RADIUS server MFA. Also knownas Push OTP. AppGate ZTNA requests that the RADIUS server validate the user, and the RADIUS server prompts the user for an OTP.

      • User Password. If selected, the User-Password field of the RADIUS request contains the user's password.

      • User Shared Secret. Used as the User-Password field of the RADIUS request.

    • Appgate SDP challenge-response MFA. AppGate ZTNA requests that the RADIUS server validate the user, and then the RADIUS server requests that AppGate ZTNA prompt the user for an OTP.

      • User password. If selected, the User-Password field of the RADIUS request contains the user's password.

      • User Shared Secret. Used as the User-Password field of the RADIUS request.

  • Pin Entry Type. Select one of the following:

    • Masked. Hides the PIN as the user enters it.

    • Numeric (6 digits). Uses a numeric keypad.

    • Text. Allows alphanumeric entry.

  1. Save the provider.