The Connection Broker handles NAT traversal in the AppGate ZTNA system. This section describes how to configure a Connection Broker on an AppGate appliance.
Before adding a Connection Broker
Before adding a Connection Broker, review the NAT traversal in AppGate ZTNA section.
Configuring a Connection Broker
To configure a Connection Broker:
In the Add/Edit Appliance page, select the Connection Broker checkbox in the Functions tab.
Complete the following configuration fields:
Site Settings
Appliance Site. Select the Site from the dropdown list.
System TLS Connection (using SPA)
These settings are used for peer‑to‑peer traffic:
TLS Port. The inbound TLS connection port to the appliance.
Allowed Sources. Select +Add to add one or more allowed sources by adding the Address, Netmask Length, and the Network Interface. The requesting IP address must match at least one allowed source.
SPA Mode. Allows the SPA mode to be changed for a specific appliance. Select one of the following:
No override
Check TCP SPA key before allowing connections
Check UDP (and TCP) SPA key before allowing connections
Enable proxy protocol. When enabled, the appliance accepts only packets that include a proxy protocol header. AppGate ZTNA supports proxy protocol versions 1 and 2.
NOTE
When traffic originates from a known source, add that source to Allowed Sources. Failure to do so introduces a security risk.
Broker Configuration
STUN/QUIC Port. Enter the port used by the Connection Broker. The default value is 443.
Site Connections. Select one of the following options:
Broker connections for all Sites. Creates a broker connection for all Sites.
Broker connections for specific Sites. Creates broker connections only for selected Sites.
Sites. Select +Add to add specific Sites.
After completing the Connection Broker configuration, continue to the Miscellaneous tab.