--- title: "Adding a Connection Broker" slug: "adding-a-connection-broker-v7-0" description: "Configure a Connection Broker in AppGate ZTNA for secure NAT traversal, including TLS settings and Site connections for optimal performance." tags: ["Appliance Configuration", "Appliance Functions", "Connection Broker"] updated: 2026-10-05T18:45:04Z published: 2026-10-05T18:45:04Z canonical: "support.appgate.com/adding-a-connection-broker-v7-0" --- > ## Documentation Index > Fetch the complete documentation index at: https://support.appgate.com/llms.txt > Use this file to discover all available pages before exploring further. # Adding a Connection Broker The Connection Broker handles NAT traversal in the AppGate ZTNA system. This section describes how to configure a Connection Broker on an AppGate appliance. --- ## Before adding a Connection Broker Before adding a Connection Broker, review the [NAT traversal in AppGate ZTNA](/v1/docs/nat-traversal-in-appgate-v7-0) section. --- ## Configuring a Connection Broker To configure a Connection Broker: 1. In the **Add/Edit Appliance** page, select the ***Connection Broker*** checkbox in the **Functions** tab. 2. Complete the following configuration fields: ### Site Settings - ***Appliance Site***. Select the Site from the dropdown list. ### System TLS Connection (using SPA) These settings are used for peer‑to‑peer traffic: - ***TLS Port***. The inbound TLS connection port to the appliance. - ***Allowed Sources***. Select **+Add** to add one or more allowed sources by adding the *Address*, *Netmask Length*, and the *Network Interface*. The requesting IP address must match at least one allowed source. - ***SPA Mode***. Allows the SPA mode to be changed for a specific appliance. Select one of the following: - *No override* - *Check TCP SPA key before allowing connections* - *Check UDP (and TCP) SPA key before allowing connections* - ***Enable proxy protocol****.* When enabled, the appliance accepts only packets that include a proxy protocol header. AppGate ZTNA supports proxy protocol versions 1 and 2. > [!NOTE] > NOTE > > When traffic originates from a known source, add that source to *Allowed Sources*. Failure to do so introduces a security risk. ### Broker Configuration - ***STUN/QUIC Port***. Enter the port used by the Connection Broker. The default value is 443. - ***Site Connections***. Select one of the following options: - *Broker connections for all Site*s. Creates a broker connection for all Sites. - *Broker connections for specific Sites*. Creates broker connections only for selected Sites. - **Sites**. Select **+Add** to add specific Sites. After completing the Connection Broker configuration, continue to the [**Miscellaneous**](/v1/docs/adding-a-new-appliance-v7-0#miscellaneous) tab.