Hardware appliance spec

Prev Next

AppGate ZTNA is available on the following physical appliance models, specified to deliver both affordability and high performance.


Specifications

The following table describes the specifications for each appliance model:

Parameter

Ax-M2

AX-J

Primary and
Secondary usage

  • Connector

  • Gateway/LogForwarder (only one at a time)

  • Controller/PortalGateway

  • LogServer

Concurrent Users (GW)

100-250 maximum per unit*

5,000-10,000 maximum per unit*

Throughput

0.85Gb/s maximum

50 Gb/s maximum

Memory

8GB

16GB

CPU(s)x

1x Intel® Pentium® J6426 2.0Ghz, 4C

Intel® Xeon® 6 Performance 6517P 3.2G, 16C/32T, 24GT/s, 72M Cache, Turbo, (190W) DDR5-6400

Disk(s)

1x SSD SATA 128GB

480GB SSD SATA Mixed Use 6Gbps 5 12 2.5in Hot-plug AG Drive, 3 DWPD

Networkx

4x 1Gb RJ45 Ethernet

4x 1Gb RJ45, 4x 25Gb SFP28 Ethernet (SFP+ supported) ^

Power Supply Unit

Single external

Dual 800 W redundant hot pluggable

Management

n/a

iDRAC10, Enterprise 17G

x Due to component availability, the exact CPU and network specifications may vary from those shown.

* Concurrent user capacity depends on the number of users and the complexity of entitlements. Memory requirements relate to the number of users and the complexity of associated conditions. CPU requirements relate to network activity and the frequency of condition changes.

NOTE

Individual users can achieve speeds up to the typical 1 GbE interface speed of their device.

^ Ax-J appliances use Intel® E810-XXV network adapters with two or four 10/25Gb SFP28 ports. To use these ports, SFP28 connector modules must be added. SFP+ connector modules are also compatible but are limited to 10 Gb. Connector modules are not included with the appliance, as they are typically part of the cable assembly. These are standard networking components that must be purchased locally to suit your switches. AppGate does not sell or supply these items. For details, see the 25Gb Intel data sheet.

Rear views

Interface numbering in the rear view corresponds to the interface numbers used in an appliance’s System Settings. For example, interface 1 appears as eth1 in the admin UI. The exact appearance of the rear panel may vary from the layout shown below.

Diagram showing network ports and power supply units for Ax-J configuration.